| Voltage Type |
Boost |
| Vout (Max) (V) |
11 |
| SRAM (kB) |
8 |
| Istandby (μA) |
5 |
| IO Level (V) |
1.8
3.3 |
| AAE |
YES |
| Input Signal |
IIC
3TRIG |
| LRA Calibration |
LCC2.0 |
| Temperature |
-40℃~85℃ |
| TikTap |
YES |
| Package (mm) |
FCQFN 2X3-20L |
1MHz I2C Bus
8-KByte Memory
12k/24k/48k input wave sampling rate
F0 detect and tracking
Advance autobrake engine integrated
Playback mode:
Real time playback(Up to 4KByte FIFO)
Memory playback
3 Trigger playback
One wire playback
Cont playback
Resistance-Based LRA Diagnostics
Drive signal monitor for LRA protect
Drive Compensation Over Battery Discharge
Fast Start Up Time < 1ms
Dedicated interrupt output pin
Boost output voltage up to 11V
VOUT=8.5V @ Vbat=4.2V for 8Ω LRA
Support automatically switch to standby mode
Standby current：5μA @ Vbat=3.6V
Shutdown current：0.1μA
Supply voltage range 3 to 5.5V
Short-Circuit Protection, Over-Temperature Protection, Under-Voltage Protection
FCQFN 2mm X 3mm X 0.55mm -20L Package
Support Tiktap haptic game solution for Gamepad/AR/VR/MR
AW86927G is a high voltage H-bridge, single chip LRA haptic driver, with F0 detecting and tracking based on BEMF, with a boost converter up to 11V drive voltage inside, supporting real time playback, memory playback, cont playback, one wire and hardware pin trigged playback. A typical startup time of 1ms makes the AW86927G an ideal haptic driver for fast responses.
AW86927G integrates a 8KByte SRAM for user-defined waveforms to achieve a variety of vibration experiences, supporting 3 sampling rate(12k/24k/48k) of waveforms loaded in SRAM, supporting output waveform sampling rate up-sampling to 48k.
AW86927G integrates an autobrake engine to suppress the aftershocks to zero for different drive waveforms(short or long) on different LRA motors.
AW86927G supports LRA fault diagnostic based on resistance measurement and protections of short-circuit, over-temperature and under-voltage.
AW86927G integrates a high-efficiency boost converter as the H-Bridge driver supply rail. The output voltage, maximum current limit and maximum boost current are configurable.
AW86927G features configurable automatically switch to standby mode after haptic waveform playback finished. This can less quiescent power consumption. The RSTN pin provides further power saving by fully shut down the whole device. Dedicated interrupt output pin can detect real time FIFO status and the error status of the chip.
AW86927G features general settings are communicated via an I2C-bus interface and its I2C address is configurable.
AW86927G is available in a FCQFN 2mm x 3mm x 0.55mm -20L package.
