| Voltage Type |
Boost |
| Vout (Max) (V) |
10.5 |
| SRAM (kB) |
8 |
| Istandby (μA) |
8 |
| IO Level (V) |
1.8
3.3 |
| AAE |
NO |
| Input Signal |
IIC
3TRIG |
| LRA Calibration |
LCC1.0 |
| Temperature |
-40℃~85℃ |
| TikTap |
YES |
| Package (mm) |
FCQFN 2X3-20L |
1MHz I2C Bus Control(Address: 0x5A/0x5B)
LRA Resonant Frequency Detect and Tracking Option
LRA Fault Diagnostics based on Resistance
Drive Compensation Over Battery Discharge
Integrated 8-KByte Internal Waveform Memory
Up to 4-KByte Configurable FIFO Interface
Flexible Playback Modes:
Real Time Playback, Memory Playback, Hardware Trigger Playback and CONT Playback
1.2ms Fast Start Up Time
Support ≥ 8Ω LRA
Up to 3 Hardware Pins Trigger Input
Dedicated Interrupt Output Pin
High Voltage H-Bridge Driver
Integrated Boost Output Voltage up to 10.5V
Support Automatically Switch to Standby Mode
Standby Current: 8μA
Shutdown Current: 0.2μA
3V to 5.5V Supply Voltage Range
Short-Circuit Protection, Over-Temperature Protection, Under-Voltage Protection
FCQFN 3mm x 2mm x 0.55mm -20L Package
The device is the high voltage H-bridge, single chip LRA haptic driver, with LRA resonant frequency detect and tracking, with an integrated boost converter and integrated waveform memory, supporting real time playback and hardware pin trigger playback. Maximum drive voltage is up to 10.5V and a typical startup time of 1.2ms makes the device an ideal haptic driver for fast responses.
The device supports software controlled LRA resonant frequency(F0) detect, it can detect the actual F0 after LRA delivered to customer in the actual F0 after LRA mounted in the mobile.
The device supports LRA resonant frequency tracking based on LRA BEMF. It supports automatically tracks and generates the LRA resonant frequency.
The device supports LRA fault diagnostic based on resistance measurement.
The device supports real time playback for long waveform play. Software trigger and hardware trigger are supported for different applications.
The device integrates a high-efficiency boost converter as the H-Bridge driver supply rail. The output voltage, maximum current limit and maximum boost current are configurable.
The device features configurable automatically switch to standby mode. This can less quiescent power consumption. Dedicated interrupt output pin can detect real time FIFO status and the error status of the chip.
The device offers short circuit protection, over-temperature protection, under-voltage protection to protect the device.
The device features general settings are communicated via an I2C -bus interface and its I2C address is configurable.
The device is available in a FCQFN 3mm x 2mm x 0.55mm -20L package.
